Loading Paper Loading Continuous Paper 1. Do not stack the ribbon cartridge sideways, it will cause poor quality printing. Į – 12 Important: Do not peel off the plastic film (ribbon mask) on the top of the cartridge. To remove a ribbon, move the cartridge to the position indicated by two arrow icons at. Turn the take-up knob in the direction of the arrow icon to tighten the ribbon. Insert the flat end of the cartridge into the upper part of the ribbon plate, then lower the front of the cartridge over the printhead until it snaps into place. Important: a) The printhead gets very hot during extended periods o. There is a cut-out at the centre of the sheet guide for changing cartridges. Slide the print head gently towards the centre to give yourself some working room. Set the headgap lever to the “R” position. Į – 10 Installing the Ribbon Cartridge 1. Fasten the the cable using the wire clips that can be found on both sides of the connector port. Plug the interface cable into the port on the back of your printer. Make sure that both the printer and the computer are switched OFF. Į – 9 Connecting to the Computer These instructions are for the standard centronics parallel interface. Do not use an adapter because it will defeat the earthing. Important: Make sure the socket is earthed. Plug the other end into an earthed socket.
Plug the power cord into the back of the printer. Gently press the other leg until it slips into the other hole. Put the stud of one of the stacker’s legs into the hole at the end of the rear vent. (To transport the printer long distances, make sure to r. Remove this shipping retainer and keep it with the other packing materials. There is a shipping retainer to protect the printhead from jamming. Hold both sides of the access cover and lift up.
Į – 6 Preliminaries Before plugging in the printer, follow these steps to install your printer. Make sure you have everything shown below: ➢ MICROLINE 320/390 FLATBED printer ➢ Sheet stacker ➢ Power cord ➢ Ribbon cartridge ➢ Printer Handbook No. Gently remove the printer from its carton. Į – 5 Installing Your Printer Prior to unpacking the printer, find a flat, sturdy surface to place it on, for example, a desk, printer stand, etc. Į – 4 Important Wiring Instructions The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live If the colours of the wires in the mains lead of this printer do not correspond with the markings of the terminals of your plug, proceed as follows: Green and Yellow must be connected t. ➢ Always disconnect the printer from the mains source before cleaning. However, as with all electrical equipment certain precautions should be allowed: ➢ Read all documentation supplied with and on the printer before commencing. Į – 3 Important Safety Instructions Your printer has been carefully designed to perform safely and reliably.
Oki also can not guarantee that changes in software and equipment made by other manufacturers and referred to in this book will not affect the applicabi. Oki assumes no responsibility for errors beyond its control.
Į – 2 Note to Customers Every effort has been made to ensure that the information in this manual is complete, accurate and up-to-date. Į – 1 English Table of Contents Note to Customers.
MICROLINE 320/390FB User Manual (English) MICROLINE 320/390FB User Manual (English).